< > operators
Posted: Tue Dec 07, 2021 4:44 pm
Hello,
Some instructions make use of < > operators, I was told they are intended to ease selection of low or high order byte of an expression.
However, I get a " Syntax error in expression" error while assembling with pceas2.exe. Is it that usage of those operators is non standard and not supported by all assemblers?
Thanks a lot in helping me.
Some instructions make use of < > operators, I was told they are intended to ease selection of low or high order byte of an expression.
However, I get a " Syntax error in expression" error while assembling with pceas2.exe. Is it that usage of those operators is non standard and not supported by all assemblers?
Thanks a lot in helping me.